INSTALLING LATTICE UNDER DECK VIDEO INSTALL

Having the plywood to cut into will keep the lattice from 'chattering.' Because lattice is built from sections of small lathes in a criss-cross section, it will bounce when it is cut if not on a stable surface. Adjust the blade so that the blade will be 1/4 inch below the lattice.

Set the lattice work on top of the plywood. You are going to cut into this too, so it will be wise to use an old piece or a few pieces of scrap put together. Set a piece of plywood either on a stable surface or on sawhorses. Lattice is a decorative panel that can be used to hide unsightly areas under your deck while also providing ventilation. The most efficient way is to cut the lattice with a circular saw.

There are several different ways to cut lattice.

INSTALLING LATTICE UNDER DECK VIDEO INSTALL

When you go to install the lattice work, you will see that this will give it a nice finish look. Measure the lattice from the outer edges of the vertical boards and the inside edges of the horizontal boards. If I just add another 12' fascia all the way across then I will be even with the. As you follow the deck across to the other side, the ground slopes more leaving about 16' from the existing fascia to the ground. On the one side of the deck, it measures about 12' from the existing fascia to the ground. Lattice comes in two size sheets: two feet by four feet and four feet by four feet. The front of the deck measures 30 across. Step 2 - Take Measurements for LatticeĪfter the frames are built for the lattice work to be installed on, you can take the actual measurements for the lattice. When a frame is not used, you will be trying to work with the contour of the ground. This frame acts as a guide for your measurements so that you always have a straight edge to measure against. The easiest way to install lattice panels is to build a frame for the lattice to be attached to.

Installing lattice under deck video